La-z-boy Power Recline 11/28/2011-12/31/2012 User Manual download pdf (Page 6)

La-Z-Time

Power Motion-Modulars

Assembly Instructions

NOTICE: Do not plug in until instructed.

1. Gently roll the power motion-modular unit forward to rest on the seat and top arm. Cut the

plastic ties and remove the protective packaging under the power motor.

2. Remove the twist tie from the motor connector cord. Route the motor connector cord between

the motor cover and the base rail (F

IGURE 1). Gently roll the unit back to the upright position.

3. The power transformer box and the electrical component bag are attached to the back springs on

the power motion-modular units back. Lay the power motion-modular units back, front side down,

on the seat and lift the outside back upholstery cover to locate the parts (FIGURE 2). Cut the plastic

tie and remove the power transformer box and the electrical component bag from the back springs.

• Remove the power transformer from the box and set aside (FIGURE 3).

• Remove the cord from the bag and set aside. The electrical component bag for the power

motion-modular units contains the 120 volt power cord (F

IGURE 3).

– To reduce the risk of injury:

• Do not operate the unit until the back is installed and locked.

WARNING

4. Install the backs.

• Lay the back on the seat, and locate the back and body brackets (FIGURE 2). Lift the back at

a slight angle and align the brackets on the back with the brackets on the body.

• Lower the back onto the body, making sure the back and body brackets are completely engaged.

- Lift the back upholstery cover to visually confirm that both sets of back and body brackets

are engaged (F

IGURE 4). If one or both brackets are not engaged, remove the back and

repeat the steps above.

- If you are unable to install the back properly, contact your La-Z-Boy

dealer for assistance.

• Lock the brackets by using a screwdriver to push down the locking levers (FIGURE 5).

5. Locate the fastening tape on the outside back upholstery cover and the fastening tape on

the bottom of the rear rail (F

IGURE 6).

• Pull the outside back upholstery cover down tight, and firmly press the fastening tape

on the outside back upholstery cover to the fastening tape on the bottom of the rear rail.

6. Choose a location for the power motion-modular unit that is close to an electrical outlet.

(Power Motion-Modulars Assembly Instructions Continued)

La-Z-Time

Power Motion-Modulars

Assembly Instructions

Base

Rail

FIGURE 1FIGURE 2

IGURE 3FIGURE 4

IGURE 5FIGURE 6

Motor

Cover

Motor

Connector Cord

Back

Bracket

Body

Bracket

Power Transformer Box and

Electrical Components Bag

Back and Body

Brackets Engaged

Fastening Tape

Power

Transformer

120 Volt

Power Cord

Back

Bracket

Locking

Lever

Locking

Position

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

La-z-boy Power Recline 11/28/2011-12/31/2012 User Manual Page 6

Comments to this Manuals

Related products and manuals for Furniture La-z-boy Power Recline 11/28/2011-12/31/2012